RE: Two extra Characters at the beginning of the XML when received byserver

["Rick Connor" <rconnor@xxxxxxxxxxxxx>]

What exactly are the characters?

See if they are a "byte order mark"

http://en.wikipedia.org/wiki/Byte_order_mark


-----Original Message-----
From: ftpapi-bounces@xxxxxxxxxxxxxxxxxxxxxx
[mailto:ftpapi-bounces@xxxxxxxxxxxxxxxxxxxxxx] On Behalf Of Zimmerman,
Donald W.
Sent: Friday, May 28, 2010 8:17 AM
To: ftpapi@xxxxxxxxxxxxxxxxxxxxxx
Subject: Two extra Characters at the beginning of the XML when received
byserver

We are using the following procedure and the people receiving the XML
are indicating there are two extra characters in the beginning of the XM
(almost like what you see when using a variable length field). We have
tried a number of things to try and remove these characters from the XML
but when we look at it prior to being sent we do not see them. They are
insisting it is on our end. Does any one have any ideas? Here is the
procedure call.



Eval      Rc = http_url_post(%Trim(PostDtl):

                             %Addr(Data)   :

                             %Len(%Trim(Data))

                             %Trim(InpOutFile$)





Donald W Zimmerman

PMSI

Application Development Lead

(813) 318 6828 (Office)

(918) 527 3999 (Cell)

WFH (Thu and Fri)






Notice: THIS DOCUMENT MAY CONTAIN CONFIDENTIAL OR PROPRIETARY
INFORMATION, INCLUDING PATIENT HEALTH INFORMATION THAT IS PROTECTED
UNDER HIPAA AND OTHER STATE AND FEDERAL CONFIDENTIALITY LAWS. PLEASE
DELIVER IMMEDIATELY ONLY TO THE INTENDED RECIPIENT. IF THIS TRANSMISSION
WAS RECEIVED IN ERROR, PLEASE CONTACT THE SENDER IMMEDIATELY AND DO NOT
DISTRIBUTE THE INFORMATION TO ANY OTHER PERSON.
-----------------------------------------------------------------------
This is the FTPAPI mailing list.  To unsubscribe, please go to:
http://www.scottklement.com/mailman/listinfo/ftpapi
-----------------------------------------------------------------------