QLNXE(4)               FreeBSD Kernel Interfaces Manual               QLNXE(4)

NAME
     qlnxe - Cavium 25/40/100 Gigabit Ethernet & CNA Adapter Driver

SYNOPSIS
     To compile this driver into the kernel, place the following lines in your
     kernel configuration file:

           device qlnxe

     To load the driver as a module at boot time, place the following line in
     loader.conf(5):

           if_qlnxe_load="YES"

DESCRIPTION
     The qlnxe driver supports IPv4 checksum offload, TCP and UDP checksum
     offload for both IPv4 and IPv6, Large Segment Offload for both IPv4 and
     IPv6, Jumbo frames, VLAN Tag, Receive Side scaling, HW and Soft LRO.  For
     further hardware information, see http://www.qlogic.com/.

HARDWARE
     The qlnxe driver supports 25/40/100 Gigabit Ethernet & CNA Adapter based
     on the following chipsets:

     •   QLogic 45000 series
     •   QLogic 41000 series

SUPPORT
     For support questions please contact your Cavium approved reseller or
     Cavium Technical Support at http://support.qlogic.com, or by E-mail at
     <support@qlogic.com>.

SEE ALSO
     altq(4), arp(4), netintro(4), ng_ether(4), ifconfig(8)

HISTORY
     The qlnxe device driver first appeared in FreeBSD 11.1.

AUTHORS
     The qlnxe driver was written by David C Somayajulu at Cavium Inc.

FreeBSD 13.1-RELEASE-p6           May 9, 2017          FreeBSD 13.1-RELEASE-p6