QLXGB(4)               FreeBSD Kernel Interfaces Manual               QLXGB(4)

NAME
     qlxgb - QLogic 10 Gigabit Ethernet & CNA Adapter Driver

SYNOPSIS
     To compile this driver into the kernel, place the following lines in your
     kernel configuration file:

           device qlxgb

     To load the driver as a module at boot time, place the following line in
     loader.conf(5):

           if_qlxgb_load="YES"

DESCRIPTION
     The qlxgb driver supports IPv4 checksum offload, TCP and UDP checksum
     offload for both IPv4 and IPv6, Large Segment Offload for both IPv4 and
     IPv6, Jumbo frames, VLAN Tag, and Receive Side scaling.  For further
     hardware information, see http://www.qlogic.com/.

HARDWARE
     The qlxgb driver supports 10 Gigabit Ethernet & CNA Adapter based on the
     following chipsets:

     •   QLogic 3200 series
     •   QLogic 8200 series

SUPPORT
     For support questions please contact your QLogic approved reseller or
     QLogic Technical Support at http://support.qlogic.com, or by E-mail at
     <support@qlogic.com>.

SEE ALSO
     altq(4), arp(4), netintro(4), ng_ether(4), ifconfig(8)

HISTORY
     The qlxgb device driver first appeared in FreeBSD 10.0.

AUTHORS
     The qlxgb driver was written by David C Somayajulu at QLogic Corporation.

FreeBSD 13.1-RELEASE-p6        November 3, 2011        FreeBSD 13.1-RELEASE-p6