QLXGBE(4)              FreeBSD Kernel Interfaces Manual              QLXGBE(4)

NAME
     qlxgbe - QLogic 10 Gigabit Ethernet & CNA Adapter Driver

SYNOPSIS
     To compile this driver into the kernel, place the following lines in your
     kernel configuration file:

           device qlxgbe

     To load the driver as a module at boot time, place the following line in
     loader.conf(5):

           if_qlxgbe_load="YES"

DESCRIPTION
     The qlxgbe driver supports IPv4 checksum offload, TCP and UDP checksum
     offload for both IPv4 and IPv6, Large Segment Offload for both IPv4 and
     IPv6, Jumbo frames, VLAN Tag, and Receive Side scaling, ability to select
     either HW or Software LRO, when LRO is enabled (default HW LRO).  For
     further hardware information, see http://www.qlogic.com/.

HARDWARE
     The qlxgbe driver supports 10 Gigabit Ethernet & CNA Adapter based on the
     following chipsets:

     •   QLogic 8300 series

SUPPORT
     For support questions please contact your QLogic approved reseller or
     QLogic Technical Support at http://support.qlogic.com, or by E-mail at
     <support@qlogic.com>.

SEE ALSO
     altq(4), arp(4), netintro(4), ng_ether(4), ifconfig(8)

HISTORY
     The qlxgbe device driver first appeared in FreeBSD 10.0.

AUTHORS
     The qlxgbe driver was written by David C Somayajulu at QLogic
     Corporation.

FreeBSD 13.1-RELEASE-p6          April 1, 2013         FreeBSD 13.1-RELEASE-p6